PolyLevel® Vs. Mudjacking and How to Fix Sinking Concrete
Sunken concrete creates trip hazards, collects standing water, and makes a property look neglected. If you are searching for how to fix sinking concrete, you will run into two main lifting methods. PolyLevel® vs. mudjacking comes down to weight, cleanup, and how long the repair holds up once the work is done.
Why Concrete Sinks
A slab only performs as well as the ground beneath it. When soil washes out, compacts, or shifts, voids form under the concrete and the slab drops into them. Lifting the slab without filling those voids leaves the problem in place, so both methods work by filling the empty space and raising the concrete.
How Mudjacking Works
Mudjacking pumps a thick slurry of soil, cement, and water through holes crews drill in the slab. The slurry fills the void and pushes the concrete upward. It can raise a slab, but the material is heavy, and that added weight can press on soil that was already soft. Moisture can also wear the slurry down over time, which may let the slab settle again. Mudjacking also needs more time to cure before the area is ready for use.
How PolyLevel® Works
PolyLevel® injects high-density polyurethane foam beneath the slab through small holes drilled into the slab. The foam expands, fills the voids, and lifts the concrete back into position. Because the foam is lightweight, it doesn’t overload the soil underneath. It also resists water, so it doesn’t wash out the way slurry can. PolyLevel® is environmentally friendly and safe to be used in and around water. Return to service takes just 15 minutes after installation is complete, and you can drive on a repaired driveway after those 15 minutes.
Concerned about your water? PolyLevel® is environmentally friendly. NSF/ANSI/CAN 61 considers it safe in and around drinking water.
PolyLevel® vs. Mudjacking Side by Side
This side-by-side look at PolyLevel® vs. mudjacking shows where the two methods differ most:
- PolyLevel® foam is lightweight, while mudjacking slurry adds a heavy load to the soil below the slab.
- Injection holes are small, while mudjacking typically needs larger ones that leave more noticeable patches.
- Return to service takes 15 minutes after installation, compared with 1 to 4 days for mudjacking.
- Foam resists water and washout, but slurry can erode as moisture moves through the soil.
- Cleanup is simpler, since there is far less material to mix, pump, and clear away.

What Decides the Right Repair for Your Concrete?
For most properties, the slab and soil point to the right method. The size of the slab, how far it has dropped, how much void sits beneath it, and the condition of the concrete all play a part. Lifting works best when the concrete itself is still in good shape, since the goal is to raise the slab and not replace it.
At Total Foundation Solutions, our System Design Specialists look at those conditions and recommend the method that fits the job. For sinking concrete in Erie, that recommendation is PolyLevel® in most cases, because it lifts the slab without adding heavy load to the ground.
Get a Free Estimate for Your Sinking Concrete
A sunken slab rarely fixes itself, and the gap tends to grow as the soil keeps moving. If your driveway, sidewalk, patio, or garage floor has dropped, an early evaluation can keep a small repair from turning into a larger one. Contact Total Foundation Solutions or call 814-273-0945 to schedule your free estimate.